Product Description
Electrical Science 328-in-1
STEM Science Toy
Educational science kit for children aged 8 and up
Product Analysis
1. Rotating warning light 2. AM (Amplitude Modulation) Rotation 3. Diode 4. PNP/NPN transistor 5. UFO/bell-style motor 6. Gyroscope 7. Rectifiers | 8. Digital display tube 9. 4 music ICs 10. 4 LED lights 11. Magnetic switch 12. Push-button switch 13. Touch switch | 14. Light-controlled switch 15. 5 capacitors 16. Sound-controlled switch 17. Variable resistor 18. FM radio 19. AM radio |
Experimental Project Showcase
1. Magnetic switch triggers frog croaking sound + digital
display shows "U" (Experiment 300)
Experiment 300: Magnetic-controlled frog croaking sound with a "U" displayed on a digital tube. Turn on the main switch, and the LED at the bottom-right corner of the digital tube will light up. Then, use a magnetic rod to touch both terminals of the reed switch; you will hear a frog croaking sound from the speaker, while the digital tube displays the character "U".
2. Light-Activated AM Radio with Adjustable Volume (Experiment 272)
Turn the variable resistor (the red knob) clockwise to switch on the main power; the LED will light up, indicating that the circuit is active. Then, move the device to a location with bright light and slowly rotate the variable capacitor to tune in clear AM radio signals.
3. Remote-Controlled Spinning Top (Experiment 18)
Mount the spinning top onto the motor and turn on the main switch; the top will begin to spin at high speed. After a few seconds, press the launch button (push-button switch), and you will see the spinning top drop! Warning: Do not hold the push-button switch down for an extended period, as this will cause a short circuit in the entire system, leading to overheating.
4. Sound-Activated Filter Disc Switch (Experiment 58)
Once you have completed the circuit connections, use the variable resistor to adjust the setting to the point where the motor is on the verge of moving but remains stationary. After this calibration, speaking loudly or clapping in front of the microphone (Microphone 19–20) will cause the filter disc to begin rotating.
| Voice-controlled | Light-controlled | Touch-controlled | Manually controlled | Magnetically controlled |
The Significance of Circuit Instruction
1. Understanding Electronic Components
Resistors, LEDs, Diodes, Audio Amplifiers
Magnetic Switches, PNP Transistors, Capacitors, Rectifiers
2. Learning About Circuits
Study series and parallel circuits as covered in middle school physics, and gain an understanding of technological circuits such as those used for light-sensing monitoring, water-level monitoring, and sound-activated lighting.
3. Logical Thinking
What may initially appear chaotic and disorganized becomes structured through the guidance provided in the manual, helping to cultivate clear logical thinking skills.
Step by Step
Allows children to understand electrical knowledge, and through continuous experimentation, promote children's understanding of physical electrochemistry. For example, why do street lights light up with a stomp of the foot but go out after a while? Why do they sound an alarm when it rains? Why does the radio play when it becomes bright? Why do the lights in the neighborhood automatically turn on when it gets dark? How do we monitor a broken wire in a city's complex circuitry? How do we monitor hazards in a mine?
List of Accessories
| Name | Quantity | Name | Quantity | ||
1. | Circuit board | 1 piece | 13. | Lower part of the spinning top | 1 unit |
| 2. | Magnetic rod | 1 piece (long/cylindrical) | 14. | Rotating warning light base | 1 piece |
| 3. | Instruction manual | 1 portion | 15. | Warning light shaft | 1 unit |
| 4. | Note card base | 1 unit | 16. | Warning light (LED) | 1 unit |
| 5. | Note card slot | 1 unit | 17. | Warning light main body | 2 unit |
| 6. | Gyro support pillar | 2 semicircles | 18. | Warning light cover | 2 unit |
| 7. | Retaining ring (for gyro) | 1 unit | 19. | Warning light gear | 1 unit |
| 8. | Gyro support arm | 1 unit | 20. | Motor with drive shaft | 1 unit |
| 9. | Motor with hanging loop | 1 unit | 21. | Warning light bottom cover | 1 unit |
| 10. | Gyro motor cover | 1 unit | 22. | Transparent warning light housing | 1 unit |
| 11. | Gyro top cover | 1 unit | 23. | Sticker | 1 sheet |
| 12. | Upper section of the gyro | 1 unit | 24. | Spring connector | 4 unit |
| 25. | Small white screw | 14 units (small, square-shaped white pieces) | |||
| 26. | Wire | 10 cm – 12 pieces, 20 cm – 12 pieces, 30 cm – 10 pieces, 40 cm – 8 pieces | |||
Connect wires according to the numbers simple to operate.
(Includes manuals in Chinese and English.)
Experiment Circuit 1
Simple Flying Saucer
Wiring Sequence: 10-6, 5-50, 51-9
When you have connected the circuit (and installed the flying saucer disc), turn on the main switch; you can see the flying saucer spinning rapidly
. A few seconds later, when you turn off the main switch, the flying saucer will fly up!
(Note: Make sure not to connect the wires in reverse)

Experiment Circuit 272
Sunlight-Activated Adjustable Volume AM Radio
Wiring Sequence: 10-107, 108-100-84-36, 35-105-102-40-27, 106-11-21-2..., 26-39-28-16-85, 101-30, 29-18, 17-86, 88-3, 4-87-89-50, 99-90, 51
Turn the variable resistor (red knob) clockwise and turn on the main switch; the LED lights up to indicate current flow
. Then move it outside to a well-lit area, and slowly rotate the variable condenser until a clear AM radio signal is heard
. Rotating the variable resistor can adjust the radio's volume
. Covering the light sensor will stop signal reception
. Note: Radio waves are sensitive to signal direction; when the radio signal is weak, please change the orientation
Experiment Circuit 301
Touch Switch Frog Croak Sound + Digital Display "U"
Wiring Sequence: 108-50, 52-55-51-4, 78-62-61-59-58-54-3, 60-97, 98-77-107, 53-75, 74-76
Turn on the main switch, and the LED in the lower right corner of the digital display will light up
. Then, dip your finger in a little salt water (this circuit requires a higher voltage, so salt water is needed) and press it on the touch switch
. You will hear a frog croak sound from the speaker, and at the same time, the digital display will show "U"
. Note: Wipe off any water stains on the touch switch after operation
. 
Front
Bottom
Side view
New imported plastic + circuit board
Product parameters

| Over 328 brands of circuit-building products | Amazingtoys LTD |
| Product Name | 328-in-1 Electronic Science Kit |
| English Name | 328+ CIRCUIT CITY |
| Product ID | 32328 |
| Recommended Age | Ages 8+ |
| Brand Origin | Hong Kong |
| Primary Material | Plastic, paper, metal wiring |
| Place of Manufacture | Dongguan |
| Certifications | EU EN71 certified, China 3C certified |
| Product Weight | 1.82 kg |
| Packaging Dimensions | 55 × 40 × 10.5 (cm) |










